Naar de inhoud
Threadline Patterns
Nederlands

Gewatteerde pannenlap – Naaipatronen

Gewatteerde pannenlap: bekijk maten, technische tekeningen, broninformatie en beschikbare PDF-bestanden. Technische instructies en bestaande PDF’s zijn in het Engels.

Maten
One Size (Universal)
Niveau
Beginner
Versie
1.1.0-review
Bijgewerkt
2026-09-11
Patroonstatus
Gepubliceerd

Technische tekeningen

Voorkant
Achterkant

PDF-bestanden downloaden

Print op 100% of werkelijke grootte, zonder aanpassen aan de pagina. Meet het controlevak op de gekozen testpagina: 50 mm of 2 inch (50,8 mm). Dit zijn verschillende lengtes. Maak eerst een proefmodel voordat je je definitieve stof knipt.

Downloaden: Instructies (PDF · 11.1 KB)Downloaden: A4 (PDF · 34.7 KB)Downloaden: US Letter (PDF · 51.4 KB)
Download het printertestblad

Maattabellen

Maateenheid

Wissel tussen centimeters en inches in alle tabellen

2. Afgewerkte kledingmaten

Maten van het genaaide kledingstuk, inclusief de bedoelde bewegingsruimte.

Veeg door de maten
Maat Tasbreedte Tashoogte
Universal 22 cm 22 cm

Maatkeuze en pasvorm

Universal one-size craft pattern with seam allowances included; verify the printed calibration square before cutting.

Toelichting op bewegingsruimte

Not applicable to this non-wearable insulated kitchen accessory.

Stof en benodigdheden

10 to 12 oz Cotton canvas, denim, or duck cloth · None (0% stable woven)

  • 10 to 12 oz Cotton canvas, denim, or duck cloth
  • Quilting cotton lining
Fabric requirements
Size45 in / m45 in / yd60 in / m60 in / yd
One Size0.50.550.50.55

Notions

  • Matching all-purpose cotton sewing thread
  • Jeans / denim sewing needle (size 90/14)
  • Insulating thermal batting core (e.g. Insul-Bright or cotton batting)
  • Double-fold bias binding tape (50 mm wide, 102 cm length)

Tools

  • Sewing machine
  • Fabric shears
  • Pins or fabric clips
  • Steam iron and ironing board

Knipplan en patroondelen

10 mm (3/8 in) included on all seams.

15 mm (5/8 in) double-fold hem.

6 mm (1/4 in) for neckband or binding attachment.

  • Potholder Outer Panels: Cut 2 in Heavy Cotton Quilted panels
  • Thermal Batting Core: Cut 2 in Insulating Batting Insulated batting
  • Hanging Loop & Bias Trim: Cut 1 Bias Binding Strip Hanging loop and perimeter trim

Press fabric before cutting to remove packing folds and pre-shrink fibers.

Align piece grainlines strictly parallel to fabric selvages.

Transfer notch markings with small 3 mm snips into the seam allowance margin.

Print Page 1 at 100% scale without page scaling. Check Metric box (50 mm x 50 mm) or Imperial box (2.0 in x 2.0 in = 50.8 mm) with a rigid ruler.

Align numbered registration marks and butt tile edges flush without overlapping untrimmed paper. Tape securely.

Naai-instructies

1

Layer Quilted Sandwich

Layer Potholder Outer Panels right sides facing out with Thermal Batting Core sandwiched securely between them. Pin or baste layers together across perimeter.

2

Quilt Grid Lines

Mark 2.5 cm diagonal diamond grid lines with tailor's chalk. Quilt through all layers with walking foot, and press seam allowances flat.

3

Attach Hanging Loop & Bias Trim

Fold hanging loop strip right sides together, stitch, turn, and baste to upper corner. Encase raw edges with double-fold bias trim right sides together, mitering corners neatly. Press finished potholder.

Problemen oplossen

Seams puckering along stitch line

Thread tension too high or needle blunt

Insert fresh needle and test balance on fabric scrap.

Wavy edge along curved perimeter

Edge was stretched while feeding into machine

Staystitch immediately after cutting and use walking foot.

Bron en licentie

Threadline Open Design Studio (quilted-studio-potholders). Distributed under CC BY-SA 4.0. Designer: Threadline Technical Team.

CC BY-SA 4.0 Threadline Technical Team

https://threadlinepatterns.org

Testinformatie

Prepared from the listed source record through a technical drafting workflow. Check the measurements, print calibration and construction details carefully, and email feedback if anything appears incorrect.

sample-pending · verified

Threadline Technical Team · Threadline review pending

Engelse bronpaginaContact

Gerelateerde patronen