1
Layer Quilted Sandwich
Layer Potholder Outer Panels right sides facing out with Thermal Batting Core sandwiched securely between them. Pin or baste layers together across perimeter.
キルトの鍋つかみ – 型紙一覧
キルトの鍋つかみの寸法表、前後の図、出典、利用できるPDFを確認できます。技術説明と既存PDFは英語です。
- サイズ
- One Size (Universal)
- 難易度
- 初心者向け
- バージョン
- 1.1.0-review
- 更新日
- 2026-09-11
- 公開状況
- 公開済み
前後の製図
PDFファイルのダウンロード
「実際のサイズ」または100%で印刷し、用紙に合わせる設定を使わないでください。選んだテスト用紙の50 mmまたは2インチ（50.8 mm）の枠を測ります。この2つは異なる長さです。本番の生地を裁断する前に試作してください。
印刷確認用シートをダウンロード寸法表
寸法の単位
すべての表でセンチメートルとインチを切り替えます
2. 仕上がり寸法表
デザイン上のゆとりを含めた、完成した衣服の寸法です。
横にスクロール
サイズ選択について
Universal one-size craft pattern with seam allowances included; verify the printed calibration square before cutting.
ゆとりについて
Not applicable to this non-wearable insulated kitchen accessory.
生地と用具
10 to 12 oz Cotton canvas, denim, or duck cloth · None (0% stable woven)
- 10 to 12 oz Cotton canvas, denim, or duck cloth
- Quilting cotton lining
| Size | 45 in / m | 45 in / yd | 60 in / m | 60 in / yd |
|---|---|---|---|---|
| One Size | 0.5 | 0.55 | 0.5 | 0.55 |
Notions
- Matching all-purpose cotton sewing thread
- Jeans / denim sewing needle (size 90/14)
- Insulating thermal batting core (e.g. Insul-Bright or cotton batting)
- Double-fold bias binding tape (50 mm wide, 102 cm length)
Tools
- Sewing machine
- Fabric shears
- Pins or fabric clips
- Steam iron and ironing board
裁断と型紙パーツ
10 mm (3/8 in) included on all seams.
15 mm (5/8 in) double-fold hem.
6 mm (1/4 in) for neckband or binding attachment.
- Potholder Outer Panels: Cut 2 in Heavy Cotton Quilted panels
- Thermal Batting Core: Cut 2 in Insulating Batting Insulated batting
- Hanging Loop & Bias Trim: Cut 1 Bias Binding Strip Hanging loop and perimeter trim
Press fabric before cutting to remove packing folds and pre-shrink fibers.
Align piece grainlines strictly parallel to fabric selvages.
Transfer notch markings with small 3 mm snips into the seam allowance margin.
Print Page 1 at 100% scale without page scaling. Check Metric box (50 mm x 50 mm) or Imperial box (2.0 in x 2.0 in = 50.8 mm) with a rigid ruler.
Align numbered registration marks and butt tile edges flush without overlapping untrimmed paper. Tape securely.
縫製手順
2
Quilt Grid Lines
Mark 2.5 cm diagonal diamond grid lines with tailor's chalk. Quilt through all layers with walking foot, and press seam allowances flat.
3
Attach Hanging Loop & Bias Trim
Fold hanging loop strip right sides together, stitch, turn, and baste to upper corner. Encase raw edges with double-fold bias trim right sides together, mitering corners neatly. Press finished potholder.
困ったときは
Seams puckering along stitch line
Thread tension too high or needle blunt
Insert fresh needle and test balance on fabric scrap.
Wavy edge along curved perimeter
Edge was stretched while feeding into machine
Staystitch immediately after cutting and use walking foot.
出典とライセンス
Threadline Open Design Studio (quilted-studio-potholders). Distributed under CC BY-SA 4.0. Designer: Threadline Technical Team.
CC BY-SA 4.0 Threadline Technical Team
https://threadlinepatterns.org検証について
Prepared from the listed source record through a technical drafting workflow. Check the measurements, print calibration and construction details carefully, and email feedback if anything appears incorrect.
sample-pending · verified
Threadline Technical Team · Threadline review pending