Stevige canvas gereedschapsrol: bekijk maten, technische tekeningen, broninformatie en beschikbare PDF-bestanden. Technische instructies en bestaande PDF’s zijn in het Engels.
Print op 100% of werkelijke grootte, zonder aanpassen aan de pagina. Meet het controlevak op de gekozen testpagina: 50 mm of 2 inch (50,8 mm). Dit zijn verschillende lengtes. Maak eerst een proefmodel voordat je je definitieve stof knipt.
Wissel tussen centimeters en inches in alle tabellen
Maten van het genaaide kledingstuk, inclusief de bedoelde bewegingsruimte.
Universal One Size craft pattern with seam allowances included.
Reinforced dimensional structure designed for daily carry utility.
Heavyweight waxed canvas, duck cloth, or 10–12 oz denim · None (0% stable woven)
| Size | 45 in / m | 45 in / yd | 60 in / m | 60 in / yd |
|---|---|---|---|---|
| One Size | 0.7 | 0.75 | 0.6 | 0.65 |
10 mm (3/8 in) included on all seams.
15 mm (5/8 in) double-fold hem.
6 mm (1/4 in) for neckband or binding attachment.
Press fabric before cutting to remove packing folds and pre-shrink fibers.
Align piece grainlines strictly parallel to fabric selvages.
Transfer notch markings with small 3 mm snips into the seam allowance margin.
Print Page 1 at 100% scale without page scaling. Check Metric box (50 mm x 50 mm) or Imperial box (2.0 in x 2.0 in = 50.8 mm) with a rigid ruler.
Align numbered registration marks and butt tile edges flush without overlapping untrimmed paper. Tape securely.
Cut two main backing panels, one pocket strip, and one top protective flap from heavy canvas. Use chalk or fabric marker to mark vertical tool slot division lines (30 mm to 60 mm intervals) across the pocket strip.
Double-fold and topstitch top edge of the pocket strip with heavy-duty thread. Double-fold and topstitch bottom and side edges of the protective foldover flap.
Position pocket strip along lower edge of one main backing panel. Stitch vertical division lines through both layers, backstitching or bartacking securely at top pocket edge for strength under tool tension.
Position raw top edge of protective foldover flap along upper margin of the inner backing panel, facing down over the tool pockets. Baste in place.
Baste folded tie straps to one side edge. Place outer canvas backing right sides together over prepared inner assembly. Stitch all four edges leaving an 8 cm opening. Clip corners, turn right side out, press, and topstitch entire perimeter 6 mm from edge, closing turning gap.
Thread tension too high or needle blunt
Insert fresh needle and test balance on fabric scrap.
Edge was stretched while feeding into machine
Staystitch immediately after cutting and use walking foot.
Threadline Open Design Studio (canvas-studio-tool-roll). Distributed under CC BY-SA 4.0. Designer: Threadline Technical Team.
CC BY-SA 4.0 Threadline Technical Team
https://threadlinepatterns.orgPrepared from the listed source record through a technical drafting workflow. Check the measurements, print calibration and construction details carefully, and email feedback if anything appears incorrect.
sample-pending · verified
Threadline Technical Team · Community Open Source Verification
Tassen en accessoires · Gemiddeld
Maten: S – 2XL (Head 54–62 cm) · Gepubliceerd
Bekijk patroon en instructiesTassen en accessoires · Beginner
Maten: One Size (Universal) · Gepubliceerd
Bekijk patroon en instructiesTassen en accessoires · Beginner
Maten: One Size (Universal) · Gepubliceerd
Bekijk patroon en instructies