Stitch Waist Darts
Fold front and back waist darts right sides together. Stitch from waistline tapering to zero at dart points. Press darts towards center.
Midirok met asymmetrische zoom: bekijk maten, technische tekeningen, broninformatie en beschikbare PDF-bestanden. Technische instructies en bestaande PDF’s zijn in het Engels.
Print op 100% of werkelijke grootte, zonder aanpassen aan de pagina. Meet het controlevak op de gekozen testpagina: 50 mm of 2 inch (50,8 mm). Dit zijn verschillende lengtes. Maak eerst een proefmodel voordat je je definitieve stof knipt.
Wissel tussen centimeters en inches in alle tabellen
Je eigen lichaamsmaten. Meet over onderkleding met een aansluitend meetlint.
Maten van het genaaide kledingstuk, inclusief de bedoelde bewegingsruimte.
Select size based on natural waist and fullest hip measurement.
The finished measurement chart provides approximately 4 cm waist ease and 8 cm hip ease across the listed size range.
Lightweight to medium-weight stable woven fabric with fluid drape · None (0% stable woven)
| Size | 45 in / m | 45 in / yd | 60 in / m | 60 in / yd |
|---|---|---|---|---|
| XS – M | 1.9 | 2.1 | 1.5 | 1.65 |
| L – XL | 2.2 | 2.4 | 1.8 | 1.95 |
| 2XL – 3XL | 2.6 | 2.85 | 2.1 | 2.3 |
10 mm (3/8 in) included on all seams.
10 mm (3/8 in) narrow hem included along the shaped high-low edge.
N/A (Skirt garment).
Press fabric before cutting to remove packing folds and pre-shrink fibers.
Align piece grainlines strictly parallel to fabric selvages.
Transfer notch markings with small 3 mm snips into the seam allowance margin.
Print Page 1 at 100% scale without page scaling. Check Metric box (50 mm x 50 mm) or Imperial box (2.0 in x 2.0 in = 50.8 mm) with a rigid ruler.
Align numbered registration marks and butt tile edges flush without overlapping untrimmed paper. Tape securely.
Fold front and back waist darts right sides together. Stitch from waistline tapering to zero at dart points. Press darts towards center.
Finish the center-back raw edges. Install the 18 cm (7 in) invisible zipper from the waistline, then stitch the remaining center-back seam below the zipper stop.
Staystitch the curved high-low hem just inside the 10 mm allowance without stretching. Clip only where needed so the narrow hem can turn smoothly.
Pin front to back right sides together, matching waist, hip, and high-hem balance marks. Stitch side seams, finish the raw edges, and press seams open.
Interface the waist facing, stitch it to the upper edge, understitch, and turn inside. Turn the shaped hem 5 mm twice, easing rather than stretching the curves, then edgestitch.
Thread tension too high or needle blunt
Insert fresh needle and test balance on fabric scrap.
Edge was stretched while feeding into machine
Staystitch immediately after cutting and use walking foot.
Original in-house pattern created for Threadline Patterns. Released under Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0).
CC BY-SA 4.0 Threadline Technical Team
https://freesewingpattern.com/patterns/asymmetric-midi-skirt/Prepared from the listed source record through a technical drafting workflow. Check the measurements, print calibration and construction details carefully, and email feedback if anything appears incorrect.
sample-pending · verified
Threadline Technical Team · Threadline Digital Pattern Review
Jurken en rokken · Gevorderde beginner
Maten: XS – 3XL · Gepubliceerd
Bekijk patroon en instructiesJurken en rokken · Beginner
Maten: XS – 3XL · Gepubliceerd
Bekijk patroon en instructiesJurken en rokken · Beginner
Maten: XS – 3XL · Gepubliceerd
Bekijk patroon en instructies